FEP Resin High Speed Extrusion
Specification of FEP Resin High Speed Extrusion
1:Appearance: Translucent Particle
2:Tensile Strength: Min 16-20Mpa
3:Elongation at break: Min 250-300%
4:Relative Gravity: 2.14-2.17
Introduction of FEP Resin High Speed Extrusion
The melting point of FEP crystallization is 304 ℃ and the density is 2.15g / c (g/cubic centimeter). It is a kind of soft plastics, its tensile strength, wear resistance and creep resistance are lower than that of many engineering plastics. It is chemically inert and has a low dielectric constant (2.1) in a wide range of temperatures and frequencies. The material does not ignite and can prevent the flame from spreading. It has excellent weathering resistance and low friction coefficient. It can be used from low temperature to 392F. Also has the good processing performance of thermoplastic.
Fluorinated Ethylene Propylene, also referred to as FEP, is a form of fluoropolymer insulation. FEP is very resistant to chemicals, has a broad temperature range and it exhibits excellent electrical properties. Due to these physical and electrical characteristics FEP is an excellent choice for use in chemical, medical, electronic and aerospace industries. A common use for FEP in military applications would be in coaxial cables such as M17/113-RG316, commonly referred to as RG316 coaxial cable
Perfluorinated ethylene-propylene copolymer for high-speed extrusion (DS618)
Fluoropolymer DS618 are high molecular weight resins of low melt index,with low extrusion temperature,high extrusion speed which is 5-8tims of ordinary FEP resin. It is soft,anti-burst and has good toughness.
Quality Specification of FEP Resin High Speed Extrusion DS618
Translucent particles,without impurities such as metal debris and sand,containing visible black particles percentage point less than 2%
Elongation at break ≥
Heat stress Cracking Resistance
Main Applications of FEP Resin High Speed Extrusion
Mainly for aviation and aerospace industry,the MTR transport vehicles,automatic switching equipment,well test equipment,flame alarm systems,high-rise buildings,fire regional wires,cables,computers,communication networks,electrical fields,particularly applicable for high-speed extrusion small-caliber wire insulation material. It is more economical when used in where no high stress cracking resistance is required.
The processing temperature should be not exceed 420°C,to prevent toxic gas from releasing.
Package,Transportation and storage of DS618
1. Packed in double layer PVC bags,then closed to overpack bags,25kg.Every bag with certification.
2. Stored in clean,cool and dry places,avoid contamination form foreign substance such as dust and moisture.
3. Nontoxic,non-inflammable,inexplosive,no corrosion,the products are transported according to non-dangerous product.
[FEP Resin Information Package]
The electrical insulation of FEP resin is very similar to that of PTFE Resin. Its dielectric coefficient from deep cold to the highest operating temperature, from 50Hz to 1010Hz UHF wide range almost unchanged, and very low, only about 2. 1. The tangent of dielectric loss angle varies slightly with frequency, but not with temperature. The volume resistivity of FEP resin is very high, which is generally greater than 1015 Ω m, and has little change with temperature and is not affected by water and moisture. Arc resistance is greater than 165s. The breakdown field of FEP Material increases with the decrease of thickness. When the thickness is greater than 1mm, the breakdown field strength is above 30kV/mm, but does not change with the change of temperature.